Recent content by Candungo
-
Turnigy/Mode 1 to Mode 2 Conversion
Radio Set Up/Controls/ Channel Order is set to RTEA Cross Trim is not selected Throttle reverse not selected Mode 2 Rud/Thr/Ele/Ail ch 1 2 3 4 I exit pressing Menu then turn it off /0n and the Throttle Warning shows again...- Candungo
- Post #5
- Forum: First Build
-
Turnigy/Mode 1 to Mode 2 Conversion
My Radio is a Turnigy 9xr pro.. When Switch ON a Throttle Warning shows up then I press: MENU/MODEL SELECT *01 New Quad. MODEL SETUP Mixer/Heli/Limits/Expo-Dr/Modes/Curves/L.Switches/Music/Safety Sws/Globals/Telementry/Voice/Timers/General/Protocal. RADIO SETUP...- Candungo
- Post #3
- Forum: First Build
-
Turnigy/Mode 1 to Mode 2 Conversion
Hi to All.... I did a firmware update on my 9xr pro radio (V.1760-Mike 4/12/16 ersky9x-r220) plus mode 1 to mode 2 conversion (no soldering /parts swap) and cant find a way how to reset the idle throttle alarm after the firmware update.How do you go around this? Thanks ....- Candungo
- Thread
- Replies: 4
- Forum: First Build