Recent content by coolhuh

Windows 10 was the problem. I had an old laptop that has windows 7 and it connected to assist. Thanks everyone.

Yes, the computer makes the sound when I plug in the USB cable

The assist will not connect to the controller. When I press a button in assist it says "Please connect to the controller"

When I move the SE switch on channel seven it changes the LED. All the way back and all the way forward makes the LED blink yellow very fast. In the middle it blinks 2 yellow fast.

The USB cable came with the NAZA, I also tried another and still nothing

I am also using windows 10, if that has any thing to do with it.

I am binded to RX, the green light on top is solid green. I am connected via S-Bus and the led is a faint green when connected to USB and quick yellow flashes when not connected

When I hook up to the assist program it says I need to connect to controller. Nothing will work on assist. I plugged the USB into my quad and the green light is on, on the receiver. When I try anything with the transmitter, nothing happens.

I just put on the NAZA M V2 w/GPS. I am using a Tranais X9D +. with X8R receiver. I was able to bind them but the quad will do nothing. I connected all the wires according to the DJI website. The reciever has a solid green light and the PMU has a blinking green light. I previously had the...

Thanks for the replys. That is what I thought it was so I checked it several times and they are correct.

Recently finished my X-Mode Alien quadcopter I built from scratch. Problem is when I tried to fly it, it did not seem to have enough power to take off. I gave it full throttle and it almost lifted off the ground but did not seem to have enough power to lift, just kind of bounced off the...