Recent content by Dark Dragon

I printed a new arm (as the last crash broke it) and tried it again. This time i tried ALT HOLD it yeilded a "BOUNCE" instead of holding altitude slowly loosing altitude. looking at the data logs THORT_IN is bouncing between 20 and 48 %. Hover.. more or less is at 30 What does this mean?

So i to total runied my 8' props at home becuase im stupid... SO i put on the 10' props instead (waint for the replacement 8s to come in). Im using a small 3s battery (only 1.5 Ah) i have and the quad does fly be it a little sensative. I was planning to do AUTO TUNE today. I took it out and...

How bout a 4s with this? NTM Prop Drive Series 28-26 1100kv / 252w https://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=25076

That motor's specs seem allot higher then the D.. For example its rated for a 4-5s Lipo where D was 3-4s im worried i'd be overpowering the droid

Hey all, im working on putting together the CrossFire 2 (3d printed quad) The sugestions is the AX-4008D motors, but they are discontinued. How do i know what motors/props to get? And where can i buy them? Also what are the differnt shaft configurations out there?