Recent content by dbutlerquad

OK, forgive me bc I'm a little slow. The Afro ESC's, which run the Simon K FW is what you're recommending? Or can I upgrade my current ESC's to SimonK? Thanks for replying!!

Is this the same as the Afro ESC?

Finished my first build with the help of my buddy but I've had some trouble with dialing it in. EMAX Multi-copter MT2213-935KV CW Brushless Motors are what I'm using and they recommend 18 amp ESC. I've found some online info that recommends multiplying the motor amps by 1.2 to 1.5 to get the...

Have a Gimbal with bgc v2.2 firmware. I can't get it to calibrate properly. It will adjust when tilted left, but on right tilt it will level, then move back to even with the quad. Does this over and over. Forward and back tilt produces no results. Newbie needs help. thanks

when you rotate it CW, right after that it rotates a bit CCW

I think yaw is the terminology in the Naza software.

When I rotate CW it will tick back CCW. This doesn't happen regularly and it only turns a small amount, probably less than 5 deg. Any ideas? Thanks

I just flew it. Flew much better! Little windy, but I think you all may have solved my issue. Ready for a calmer day. Owe you guys!!!!

If I have an external low voltage alarm do I need to use the one in the Naza?

Here are my current settings, if I'm in the right place. Advanced>Voltage First level Protection No Load 11.20v Loss.5 v Loaded 10.7v Second Level Protection No Load 11v Loss .5 v Loaded 10.5v The only cell I can edit is the loss, and only up to 1 v. Thanks for the reply

My friend helped me build my quad. Both built on the MWC X-mode Alien chassis, and both use the MT2213 935kv EMAX motors w/1045 props. Both also run a 3S 5000mah battery,the same exact brand. The first, (his)Quad #1, I built using a MultiWii Pro 3.0, from whitespy, and hobbyking red 30A ESC's...