Recent content by James Goodwin

ok, So I have a new build with Naze 32 on a ZMR250. I am having random yaw, pitch and roll issues where, a few mins into flight the quad starts to yaw to the right and pitch forward or back. My mid and end points are right. Have not tried in acro mode only angle and horizon. The only thing I can...

Firstly, I would like to thank GJH105775 for your advice. I have managed to solve the problem, well at least "Paper over the crack". It occurred to me that it could just be either ch1 or 2 or both acting up. So I decided to remap ch1 and 2 to AUX 3 and 4 and remap the other channels...

If you see channels moving its bound. you need to make sure your end points are within range or your naze wont arm.

Do you reckon it is feasible that there is an internal short or fault that is somehow bridging channels 1 and 2. I wouldnt be the first time that I have had a faulty item from HK.lol. Just wondering if I could bypass channel and remap

Yes, Values change but they change in tandem. It seems to not make any diff what mode im select. Roll and Pitch move the exact same. If I create a mix on channel one and set master and slave to 100% I can get the values to go down to 1000 on left roll but roll and pitch still move together

Hi, Thanks for the prompt reply. Yes deffo bound as I get a response in GUI and the quad lifts off ground, Just wont roll left or pitch back. I was convinced it was a TX issue but same outcome with another 4 ch tx/rx. I am thinking maybe some kind of custom mix activated in Cleanflight. Or poss...

Hi, New to the forum and to Quads, but not to the Rc World. I am hoping there is someone out there that can give me a little advice. I have built my new ZMR 250 following Bruce's instructions over at RC model reviews. The build has gone well but I am stumped with the following. I am using a...