Recent content by Jim Skelly

So are you interested, or were you just trying to be sarcastic?

You are so correct on all accounts so here ya go, 225.00 and you pay the freight.

I have an Echine 250 Racer with FPV monitor. Like new, never been crashed only needs RX/TX and Batteries. Flys great but I'm not really interested in flying FPV so it's gotta go. Comes with Bag for quad as well plus extra set of props. You pay shipping. Pay with cash or paypal PRICE REDUCTION...

I downloaded the cc3d fc software and went through the entire process including the radio part and everything looks good but I can not arm the motors. This is a bummer. I found the problem with the motors to be the DEVO rx1002. I also switched to Librepilot since Ardupilot is not longer...

Not sure what is inside the quad.

I got my echine 250 today and was able to connect to the machine with the windows 10 machine and do the firmware update for the 250, so I thought that if that worked then I might get the cheerson to work with the laptop so I connected everything and started the software. NOTHING. Same message...

Has anyone been able to get their windows 10 machine to recognize their cheerson cx 20 when plugged in to mission planner? If so, tell me what I have to do to get my windows 10 machine to recognize the cheerson.

How do you tell if you have an open source version of the cx 20?

Not sure.I will check.

Windows 10.

I went to Best Buy and bought a new USB sync cable thinking that was the problem, and when I plugged it in the laptop says the ;ast usb plugged in was not recognized with the line (device descriptor request failed.) Nothing I have tried has worked so I am at a loss for what to do at this point.

I have downloaded ardupilot to connect to my cheerson cx20 to make it a little more responsive but every cable I have connected to the laptop and the cheerson gives me a response on my laptop that the usb cable is not recognized by the laptop. My question is exactly what cable can I buy that...

you still got it? Im in destin

I am rebuilding my qrx350 pro and I did not take a pic of where all the wires plug in to on the board/controller. Anyone have a pic of the inside of the qex350 I could see?