Recent content by magic man

Thanks After checking again I found 1 motor not doing the same Rpm as the others I replaced it and all is fine Thanks again for your help

Ok I ll try that Thanks so much

Still looking for any help with my x5c sym changed battery checked for loose props Changed to hi and still it won t lift off just leans a bit Sounds like not enough power even with new 600 battery charged to 4.29 on meter Any help would be highly appericated

yes i just changed it from low to high power and still it just tilts at full throttle no lift off anything else thanks

Also How do I check for max thrust on my transmitter

Checked all props they are tight All motors seem good but it still won t lift off. When I move controls it just tilts I even changed the battery Don t know what to check next Can you advise Thanks

hi all i'm dentman again still haveing problems with my syma x5c checked for loose props there ok with throttle full the copter wont lift off the ground tried replaceing stock batteries that show a charge rate of 4.29 3.7 -680 replacement batteries props spin freely and look good. but still it...

Thanks for the advise I ll check out the props

hi am dentman i recently purchased a syma x5c quadcopter i have been flying it for a little over a week battery shows after charging 4.29 now it wont get off the ground also one motor not turning can the battery be the problem? i ordered new batteries can anyone help me

have a syma x5c and it flew great for about a week now after charging battery shows 4.28 and copter wont get off the ground also one motor not turning could that be because of the battery?

thank you for all your help

What is the proper way to calibrate thus unit

Thank you I finally found the SD card on the side of the camera. I didn't see it before Another question I have no rudder control Tried the trim ad with no luck What's next Thanks

So does that mean I can not review any videos that I take And if so how do I do it Thank you so much for your reply Magic man