Recent content by ProfFalken

Hi, I'm not sure where you're based, but I ordered this kit which contains two of each blade type, four motors and four ESCs: http://www.amazon.co.uk/gp/product/B00LM341O0?psc=1&redirect=true&ref_=oh_aui_detailpage_o01_s00 Hope that's of some help, Matt

Thanks Neil, I bought a new spinner and rotor mount yesterday and fitted them this afternoon along with some blue loctite (the guy in the shop said that red would be pushing it!). Fired up the quad and had it hover, pushed the sticks forward to make it fly and promptly crashed it! :D I see...

Wow, so well over a month since I last had any time to have a go on this and I've just managed to maiden it then crash it quite spectacularly! The auto-level kicked in fine and take off was beautiful, however during the hover one of the hubs that holds the rotors onto the motors came unstuck...

I'm working my way up to flashing the board with Stevies Firmware. I'll try and fly it with the stability mode enabled later on this week. Thanks, Matt

OK, so you were right, one of the motors was wired incorrectly! I managed to get it into the air but it was incredibly unstable so I think I need to get the self-level stuff enabled. I also think I need to recalibrate the ACC because I don't think it was "flat" to begin with, but I've had it...

OK, thanks, I'll try and give that a go over the next couple of days.

FCB arrived today, I've connected it all up and attempted to maiden it but managed to break a pair of blades in the process as it tipped forward. Any ideas what I'm doing wrong? I know that with my Heli I need a slight right-rudder to counter ground effect on takeoff, are quads the same?

Programming the ESCs is something I've not thought about yet but I guess it will need to be done - now I just need an English translation of the Chinese manual! The KK is running 2.1.5 firmware as far as I know, is there a newer version that I should be flashing, and if so, what are the...

Thanks. Antics didn't have the connectors I was after so I just went and bought some heat-shrink instead! :) I'll give the soldering a go tomorrow night. Still no sign of the KK :(

I'm writing up how to build a drone that will (eventually) have FPV/Filming support both on my thread on this forum and on my blog at https://droneonabudget.wordpress.com/ The whole thing so far (Frame, Motors, ESCs, Props and Flight Control Board) has cost me around £85GBP however it will cost...

So, for those of you not following my blog at https://droneonabudget.wordpress.com/ (and why aren't you?! ;) ) here's what I've managed to get done this week after the propellers/motors/escs arrived: ====== BEGIN UPDATE ====== This week, the motors, propellers and ESCs to control them arrived...

ESCs, Motors and blades arrived today. I've asked the vendor for more details on the ESCs as the manual is entirely in Chinese and I have no idea what it means! I'm hoping I can flash them with the SimonK firmware as I've heard good things about it in relation to stability etc, however if I...

I just found which shows how to connect a Gymbal and controller for a GoPro to the DX6i on a phantom quad so it's a simple setup :)

I'm going to be flying with a Spektrum DX6i for two reasons - the first is that I already own one and you can pick up clones of the receivers for under £10GBP...

Hi Bill, Great to see you over here and thanks for not HiJacking the thread! :D I'm waiting on my KK 2.1.5 to arrive (it's been shipped from China, should be here anytime between next Thursday and Christmas apparently :( ) however the frame arrived yesterday and my eldest daughter helped me...