Search results

Here is what happen. I had a pixhawk from radiolink. Barometer went bad and their support wanted as much as a new one to fix the old one. I bought another pixhawk which was labeled pixhawk 2.4.8 on the unit. Using the same connections I had for the previous pixhawk from the minum osd I now do...

This has happened twice. I activate RTL mode just to check it out. There was no issue happening on both occasions. I have RTL set on a separate channel /switch (channel 7) in mission planner. My other 6 modes are set using channel 5. After rearming and take off the drone initiates a landing mode...

First let me say I've connected the switcher using a ubec feeding a X8R and 2 cameras and it switches between both no issue so I know my connections are correct. I move this over to my quad and connect to aux port 4(channel 12) on the pixhawk. Program my tranis radio mixer for channel 12 for a 3...

This is a weird one. I've had my drone working fine. Had a minor mishap. After fixing frame I'm not able to arm pixhawk 4 with Tranis 9D plus. I'm able to arm in mission planner and run motors with Tranis and also disarm with Tranis moving sticks to center. Moving the left stick down and to...

I configured a Usmile Beitian NEO-M8N GPS Module with Built-in HMC5883L Compass Protective Case for Ublox PX4 PIX APM2.5/2.6 Pixhawk using UCenter which went great. When I plug into a SP Racing F3 Deluxe FC using the Uart2 port my other SoftSerial ports become disabled along with Uart2 in...

I've watch numerous videos and setting up telemetry but still can't get working. This is what I have so far. Taranis 9D Plus D4R-II SP Racing F3 Deluxe I'm using the soft serial IO2 channel 6 running 1 wire to RX port on receiver. I've set up configuration in Cleanflight for Soft serial 2...