Search results

Got two of these: https://www.gearbest.com/flight-controller/pp_638475.html F3 ACRO 6DOF Flight Controllers. One has its boot pins bridged one does not. Can't seem to flash BF or even Cleanflight. It says in CF it needs an update but when I go to choose the version I pick SPRACINGF3 and the...

I don't know about my luck lately... I was working on a problem with the VTX, which I am replacing, and when it was reassembled this began to happen, a long constant beep that does not end. It seems to be when I plug in ONE wire, without it no beep. Not sure what the log unending tone means...

OK. SO. I got the FLYSKY version, bound it and got it set up for angle/horizon/airmode. All I use angle mode for is taking off and getting used to the craft, WHICH I HAVEN'T been able to do! It does not take off like my other quads, as in UP>(very little manipulation) HOVER. I have been TRYING...

Got my new unit all set up and went to test, but didn't finish securing antennas. So of course when i landed it flipped an chopped one off. Can I splice it? Or do I have to expose 31 mm like explained in this video:

So I decided to flash Betaflight onto my Naze 32 Board (FS-1A6 receiver is/was an RTF p130 I transplanted onto a 180 mm frame) flash and firmware was no problem. I used the bind plug and followed these instructions (insert bind plug quick flash turn on FS-i6 with bind plug pressed then wait for...

So. Inspired by videos by Nick Burns and Andy RC, for my first real foray into the next level of this Hobby, I got a JJRPRO P130 battler and transplanted it onto a 180mm frame, with 4" tri blades. WHAT A DIFFERENCE. I took it out for a proper maiden flight and its awesome. I think I set up the...

So. Inspired by videos by Nick Burns and Andy RC, for my first real foray into the next level of this Hobby, I got a JJRPRO P130 battler and transplanted it onto a 180mm frame, with 4" tri blades. WHAT A DIFFERENCE. Almost too much. It is almost too responsive? I tested it and it almost...

I transplanted over my P130 Battler guts to a 180mm frame. I had to drill on the bottom to get my M2's in as the frame is a little thicker than the original. It powers up and 3 of 4 motors spin. The left rear moter WANTS to spin it moves but not much.. It just kind of jiggles there. I...

Hello all! I have a spare 130mm frame and I want to take the plunge! I own a FLYSKY Tx and I am going to use 1306 4000kv motors (not sure which ones the EMAX are nice but 15$ each is a little high for me) I need this to be on a budget (my wife is awesome but she has her limits) So I am looking...

I tried to ask this on another forum and I got crickets, it might be a dumb question. Will a the Blade Inductrix (tiny whoop) board run 8.5mm motors? I have one and I have a Parrot mambo frame and motors...