Search results

Has anyone found more info on the release date for this quad? Hubsan site (can be slow to not working at all): http://hubsan.com/productinfo_21.html Blog post: https://droneflyers.wordpress.com/hubsan-x4-h501s-fpv-quadcopter/

Hi Jackson. I thought I had seen that video, but didn't save and couldn't find it again. I understand now.

Trying to understand exactly what "adjustable gyro sensitivity" means in the comment "Latest 6-axis flight control system with adjustable gyro sensitivity", which is normally a bullet point in features for these quads. Any ideas?

Thanks for the tip on letting the motors cool down Gramps. I've got a charger and batteries in my wishlists.

Battery charged, quad in air...crash into wall ;) Several flights later and had some control some of the time. Trim seems very touchy. Practice, practice, practice :)

Thanks Gramps. Now I need more batteries.

I did more research and found the problem. This should make the the top 10 of newbie mistakes... I put the wrong prop on the motor. Of course now I'm out of battery power, so I have to wait to some actual flying, but they lasted long enough to get up off the ground. Thanks for all the help...

Motor is fine Gramps, but I'll keep that in mind as I damage more of these ;) See my next post for the rest of the story.

Hi skycopter. Yes I've held the sticks to the bottom right. I've tried that at every speed setting, even though the manual says do it at 100%. No, the one blade does not start at the the time. It starts as if there is a delay in getting enough juice.

Thanks GJH. I thought it must be something with the board.

Thanks again GJH. Frame looks fine, no cracks and everything in place. I haven't soldered anything in years. Since I just got this, I started a return process to Amazon, and ordered the Husban H107C from B&H photo. What is SMD?

Thanks GJH. Definitely on level, not sure about the solder. I don't see anything bent, but I'll look closer.

This is my first RC of any kind. Day one I was able to get it in the air, and crashed of course. Broke a prop, and replaced it. Trouble now is, I can't get it to calibrate. Show typical behavior for needing calibration, but I follow the directions and it doesn't calibrate. Any suggestions...