christianprogrammer
Material Stuff just turns to ash
I took the F3 into Beta flight once I finally got almost everything soldered up ( VTX is being Stupid and pops on the
Smoke detector every time no matter where I source its power PDB or FC..
anyway thats not my major concern at the moment )
My only oddity really is in Beta Flight I cant get the UART 3 to save serialRX !!!!!
of course I went into the later screen and set Serial RX and SBUS and saved and back and forth add infinitum but she wont save the UART 3 as serial RX
Is this a known prob... ??
I don't want to move over to UART 1 or two I have telemetry on 2 and thats a first for me ...
The upsetting thing is I was getting receiver response but then I changed the settings to UART3 SerialRX and then set the next config screen for SerialRX and SBUS thats when she lost it.
I flashed the next stable release for Omnibus & happily that took just fine but still no save in the Ports screen
Smoke detector every time no matter where I source its power PDB or FC..
anyway thats not my major concern at the moment )
My only oddity really is in Beta Flight I cant get the UART 3 to save serialRX !!!!!
of course I went into the later screen and set Serial RX and SBUS and saved and back and forth add infinitum but she wont save the UART 3 as serial RX
Is this a known prob... ??
I don't want to move over to UART 1 or two I have telemetry on 2 and thats a first for me ...
The upsetting thing is I was getting receiver response but then I changed the settings to UART3 SerialRX and then set the next config screen for SerialRX and SBUS thats when she lost it.
I flashed the next stable release for Omnibus & happily that took just fine but still no save in the Ports screen