Any help appreciated

M

Mark Blake

Member
Im having trouble wiring a Naze 32 flight controller to a new FRsky x6r receiver. first time using cleanflight as well, i wish there was someone in my area that could help. I live in northern VT.
 
when cleanflight recognizes the receiver the channels are all wrong, the throttle is on the right? there isnt even a mode that puts it there. another flight control;ler does the sane thing, and another radio and receiver do as well, im freaking lost on this. not in any you tube video instruction have i seen this one.
 
If that doesn't work try a board reset & set it up again. Don't reload any backup.
Naze where all the rage @ one point. I went through 7 in my first year.
Glad to see the back of em.
 
found a video that laid out the same thing. worked as advertised. sticks all set everything set for flight. set new channels in the radio and receiver, they don't show on Cleanflight. watched 2 different videos on how to set switches on the x9e. set 4 switches, re-bound the receiver. nothing works in Cleanflight as shown on you tube. any suggestions?
 
Your help on channel programming was spot on. Can't thank you enough! I have set 4 channels up on the transmitter, as per tarannis videos, re-bound the transmitter to the receiver, but the extra channels don't show on cleanflight like they do on the instructional video? any suggestions?
 
Mark Blake said:
Your help on channel programming was spot on. Can't thank you enough! I have set 4 channels up on the transmitter, as per tarannis videos, re-bound the transmitter to the receiver, but the extra channels don't show on Cleanflight like they do on the instructional video? any suggestions?
Click to expand...
all show on the transmitter, all show movement in the model secton, but none show up under receiver in Cleanflight.
 
Where you set modes up in the tab do the switches change the ranges.
eg Arm switch
If it they do. I would try to fly it.
It may just be a glitch. Maybe try deleting the flight program & reload it.
I used cleanflight for 3yrs & when the standalone betaflight came out I deleted both chrome apps only to find the cleanflight SA wasn't a full file to run it.
& I could not re download it so I I'm on Betaflight now. And don't even know if the cleanflight crew sorted it out.
I got 2 quads with OSD & 2 without.
Does CF have osd tab these days.
 
Board reset, swap to an earlier update. Try reload cleanflight if not download the standalone Betaflight off github.
Check the board for small splashes of solder. If any of these don't work then it has to be a fault on the board.
I found a few of the naze to have dodgy motor pins as the board was working but pin 3 signal or ground was bust some how as all 4 motors & esc's worked on the other 3 sets. Other boards just stopped kuput. Lit up but picking nothing up & no USB.
 
Back
Top