Recent content by alan chattaway

Ok so I reset my settings in cleanflight to default. Turned all settings off. Tried leds on their own. Still nothing without "save and reboot". However on a test flight this morn I noticed the leds blinking while flying. Why could this be? Voltage on the led strip is 4.2v when they are on and...

I have got my addressable leds up and running after having to put a diode inline. I have them on and working...kind of.... the only way i can get them on is to "save and reboot" my naze via cleanflight. then they come on and stay on and work fine. when i unplug the battery and usb and plug them...

can anyone spot a problem in my cli dump? i am getting really frustrated with this. The leds work great when i save and reboot via cleanflight but not once i disconnect and re connect battery???? Entering CLI Mode, type 'exit' to return, or 'help' # dump # version # Cleanflight/NAZE 1.12.0...

WS2812B Addressable RGB LED strip DC5V 32 60 144

Can anyone help please? Is it maybe a voltage problem? Should I change the diode from 4.7v to lower?? Thanks

Already watched it. It would be helpful if I could find the auto tune tab in cleanflight??

I have got my addressable leds up and running after having to put a diode inline. I have them on and working...kind of.... the only way i can get them on is to reboot my naze via cleanflight then they come on and stay on and work fine. when i unplug the battery and cleanflight and plug them back...

ok so i have spent a couple of evenings looking at auto tune in cleanflight......ormore specifically looking for auto tune. I beleive it should be under the modes tab, and to assign it a aux switch. Its not there!! can anyone point me in the right direction?

Hi, I've read a lot about pids and am starting to understand them. Having just built my first drone and done successful test flight I found that the default pids were massively off. it flighs ok after a bit of adjustments. It wobbles a bit when decending, should I increase I to solve this...

its doing my head in now, ive tried putting throttle to -100% in tx failsafe and also tried using the disarm to to stop motors when tx signal lost. i guess its def the naze 32 thats triggering the motors to spin when failsafe activates even though ive set it to 0 in the failsafe tab and have...

i tried it in clean flight via the failsafe tab and also on the cli, i just tried doing it on my tx as well, as above. still no difference. loses signal, motors stop for a split second then 10 seconds of low throttle, then off. i just want the motors to stop when it loses signal. someone please...

Hi can anybody help me. I am trying to set failsafe to completely cut motors when tx signal lost. when i test by turning tx off it goes into failsafe and low throttle mode for 10 secs. no matter if i set the failsafe throttle number to "0" or "less than min throttle" i get the same response...

What size battery would you suggest?

Also are mini esc's acceptable or substandard to normal esc?

Thanks the videos were a great help! I've posted a parts lost that needs checking under "first time build"