Help Needed! New to FPV

Fel_A10

Fel_A10

New Member
Hi Folks,

I have some experience flying cinematic DJI drones and recently decided to dive into the world of FPV. I've been practicing on simulators with my Radiomaster Pocket and felt ready to try the real thing, so I picked up a Mobula8.

Unfortunately, I haven't been able to get them to connect. I've spent hours troubleshooting, following guides, digging through forums, and even trying suggestions from ChatGPT but no luck so far.

I know this might be a bit of a naive question, but is there a known guideline or step-by-step process for binding the Radiomaster Pocket to a Mobula8? Any advice or pointers would be hugely appreciated.
 
Yes, both the radiomaster and the mobula8 are in version 3.3.1. I have updated the drone firmware in betaflight and flashed the expresslrs with the happymodel 2.4 and EP1/EP2 (as device). I suspect I did some mistake in this process, but I am not sure where.
 
I am also in contact with happymodel and today they told me they will send me a new flight controller. It is possible a hardware problem. Thanks for the help here.
 
Back
Top