Please help Soon!

Zoe

Zoe

New Member
I need help, with my diy quadcopter I am building it based off of this instructable:

https://www.instructables.com/id/The-Ultimate-PVC-Quadcopter/?ALLSTEPS

Here are the main parts I am using:
-fly sky fs-ct6b reciever and transmitter
– kk2.1.5 flight controller
– 20 a Simone escs
– 980 kv motors

On the instructable, I got stuck on step 11, when I try to arm board, nothing happens the escs don’t beep and the motors do not move.

I have done everything else, binded the rx and tx, calibrated the throttle, calibrated the escs, calibrated, the accelerometer, receiver test, reciever slider test, and I downloaded “t6 config” and set that up.

Please, help soon! I am really really new to the world of quadcopters, and rc. And I have a competition in about four days. I have read countless blogs, and forums, and have watched dozens of videos.
 
Hi on the kk set up screen do all the channels move the right way and give 100% movement to arm the kk throttle to zero and right rudder at the same time the board should bleep and arm remove the props to do any tests so it's safe you don't want to running a muck in the house
 
Ok so.... I got it to arm, and the motors moved!
But after one time, I would go to arm it and it would arm, but the motors didn't spin when I lifted the throttle.
So I tried calibrating the escs, but they wouldn't calibrate, and then I tried throttle calibrating the escs and it wouldnt throttle callibrate.
I plugged everything back normal and tried to turn on the kk2 board, and now even that won't turn on.
I am at a loss I have tried everything and I now nothing will work. Please help me! :)
 
Hi sounds like the wire from the ESC to motor one is plugged in wrong this is the main power for the KK make sure the signal wire and earth are on the pins the right way round the earth wire is on outside edge of board signal wire is the inner most pin
ESC and throttle calibration is the same thing turn on transmitter with the throttle at full then hold button 1 and 4 while they are held down plug in the battery the esc should bleep now lower the throttle to zero and they should bleep now let the buttons go( the buttons must be held down all the time for it to calibrate the ESCs )
always do this with no props on
If not all the motors spin up at the same throttle go into misc section on the KK look for min throttle its normal set on 10 adjust this 2 points and try again till all motors start and stop at the same time max is 20 points
 
Last edited:
Back
Top