syma x5c-1 camera problems

W

wilko316

Active Member
hi all new to this had this for a few weeks good pics and videos, then after i did a few 3d rolls camera stopped working no lights at all on camera , it still flys good no other problems with it , is camera dead any help please
 
If there is no card in the slot the camera will not power up.

If the card is bad, it may not power up. Try a different micro card
 
Patton said:
If there is no card in the slot the camera will not power up.

If the card is bad, it may not power up. Try a different micro card
Click to expand...

Hi the card shows up on my pc and i tried the card out of my phone so i think they are ok I will try and format it and see what that does cheers
 
When I got my X5C-1 one motor did not work.

Instead of sending it back, I looked inside and found a wire that had not been soldered properly and repaired that wire. Since then it has flown nicely.
If, after formatting the card it still won't work, you may need to open the chassis and look for a similar problem. After checking the plug for bent pins etc, of course.
 
Patton said:
When I got my X5C-1 one motor did not work.

Instead of sending it back, I looked inside and found a wire that had not been soldered properly and repaired that wire. Since then it has flown nicely.
If, after formatting the card it still won't work, you may need to open the chassis and look for a similar problem. After checking the plug for bent pins etc, of course.
Click to expand...
Cheers mate i will try that thanks for the help
 
hi did all that no wires off put it all back know one of the motors not turning very fast its binding so it wont fly orderd some more motors but i think the camera is shot it i will buy a new one and see if that works thanks for the help patton
 
yea ordered one last week 3 motors turn smooth one is very harder to turn had a good look and carnt see any thing took the motor out and the cradle turns fine motor turns fine but put them in and they bind
 
Back
Top